Disc mowers

Rotex XT

XT4  |  XT5  |  XT6  |  XT7

Rear-mounted disc mower for small and medium-sized farms.

 

Range of reliable and highly performing rear-mounted disc mowers for mowing fodder on small and medium-sized areas.

The minimum power required from PTO makes the Rotex XT applicable to low power tractors as well as in combination with front-mounted mowers.

Watch the video

 

No. of discs 5
CUTTING WIDTH 2.05 m
WEIGHT 560 kg
PTO POWER 34 hp

Focus

Thanks to the robust cutter bar, with working widths from 1.65 to 2.85 m, and the reduced pressure to the ground the Rotex XT ensure a clean cut, optimal nutritional value maintenance and a well-preserved lawn, to the benefit of a superior quality fodder.

Technical Data

Rotex XT - XT5

Assembly Rear
Type Disc mower
No. of discs 5
Cutting width (mm) 2050
Conditioner No
PTO power (HP) 34
Hydraulic lift Standard
Weight (kg) 560

Structure.

  • Three-point hitch frame: the fixed frame is adjusted by means of lower cat. 2 and 3 pins used to adjust the cutter bar with respect to the tractor wheel or the overlap when working in combination with a front-mounted mower. The new fixed frame gives greater stability and robustness.
  • Impact-preventing safety unlock device to avoid any damage: in case of strong bumps against an obstacle, the device partially retracts and lifts the cutter bar.
Rotex Telaio fisso

Lightening.

Balancing and lightening of the cutter bar occur through a system of strong helical springs and tie-rods.

In this way the cutter bar can perfectly adapt to the ground contour.

 

Advantages:
  1. Less friction resulting in fuel saving.
  2. Regular cutting height.
  3. Always clean and non-contaminated fodder.
  4. Protection of the turf.
Rotex-XT Struttura

Hydraulic lifting.

The standard supplied hydraulic lifting allows lifting the bar up to +90° (i.e. vertically) during end-of-field manoeuvres and during road transfer, and it operates trouble-free on embankments and escarpments up to -35° with respect to the horizontal plane.

In transport position, the cutter bar is securely held by a mechanical device, leaving a good view for the operator at the back.

Cutting unit.

  • Gearbox, with gears in an oil bath: made from spheroidal graphite cast iron to ensure maximum resistance to stress both during work and transfer.
  • Oil bath gear transmission: the sealed ball bearings and the large gears achieve an efficient power transmission to cutting discs.
  • Discs: with cleaning flaps ensure a constantly clean cutter bar and an optimal flow of fodder.
  • Conveyor cones, mounted on the first and last disc, and adjustable tier boards to facilitate swathing of the cut grass. The rotating disc, positioned at the end of the bar, separates the swath from the grass still to be cut.
Rotex XT-XR

Protection.

  • Disc-holding flanges with safety pins: to protect internal parts in case of strong bumps of the discs against stones or obstacles.
  • Baffles in the knife overlap zones: to protect the bar should a blade bend upon contact with an obstacle.
  • Wear-resistant skids: to favour lower resistance to inching and guarantee a long life of the cutter bar.
Rotex Xt-XR Protezione

They might also interest you: